Lenze i950

4.2.1.1 Generate a connecon between inverter and »EASY Starter«
For commissioning the inverter with the »EASY Starter«, a communicaon link with the inver-
t
er is required. This can be established in a wired manner only.
Addional informaon on network conguraon: 4Congure engineering port ^ 312
Further
informaon on how to create a communicaon link via "PROFINET": 4PROFI-
NET ^ 354
How to establish a communicaon to the inverter via the engineering port X16:
Precondions
•
The funconal test described in the mounng and switch-on instrucons has been com-
ple
ted successfully (without any errors or faults).
•
The inverter is ready for operaon (mains voltage is switched on).
Required accessories
•
Engineering PC with installed »EASY Starter«
•
Standard network cable
1.Plug the network cable into the engineering port X16 of the inverter.
2.Use the network cable to connect the inverter to the PC on which the »EASY Starter« is
installed.
3.Start the »EASY Starter«.
The "Add devices" dialog is shown.
4.Select the "Ethernet" connecon.
5.Click the Insert buon.
The »EASY Starter« searched for connected devices via the communicaon path selected.
When the connecon has been established successfully, the inverter is displayed in the device
list. The inverter parameters can now be accessed via the tabs of the »EASY Starter«.
Commissioning
Operang interfaces
Engineering t
ool »EASY Starter«
30