Lenze i950

Address Name / seng range / [default seng] Info
0x2871:074 SafetyInterface bits: AIE S bus
•
R
ead only
0x2871:075 SafetyInterface bits: SHOM_Start S bus
•
Read only
0x2871:076 SafetyInterface bits: SHOM_Load S bus
•
Read only
19.23 Safe parameter seng
19.23.1 Safety address
The safety address is set using the 0xF980 parameter (safety address). Via the parameter,
addr
esses in the range of 1 ... 65534 can be set.
Parameter
Address Name / seng range / [default seng] Info
0xF980:001 Safety address: FSoE address
•
R
ead only
0xF980:002 Safety address: Safety address
•
Read only
19.23.2 Parameter set informaon
Parameter
Address Name / seng range / [default seng] Info
0x2114:001 Parameter set Idencaon: Parameter set version
•
R
ead only
1003 i950 (Extended Safety) V1.0
0x2114:002 Parameter set Idencaon: Parameter set CRC
0 ... [0] ... 4294967295
0x2115:001 Parameter set informaon: Parameter set status
•
Read only
0 No parameter set
1 Valid parameter set
4 CRC error
5 Version error
7 Plausibility error
8 Assignment error
9 Local read error
10 Communicaon error with basic device
11 Faulty release
12 Dierent CRCs
13 Changed parameter set
0x2115:002 Parameter set informaon: Safety module CRC
•
R
ead only
0x2115:003 Parameter set informaon: Last valid CRC
•
Read only
0x2115:004 Parameter set informaon: Parameter seng me
stamp
•
Read only: x s
0x2115:005 Parameter set informaon: Parameter set error infor-
maon 1
•
R
ead only
0x2115:006 Parameter set informaon: Parameter set error infor-
maon 2
•
Read only
0x2115:007 Parameter set informaon: Parameter set error infor-
maon 3
•
Read only
Safety funcons
Safe parameter seng
Parameter set informaon
449