Lenze i950

7.8.2 Mark failure detecon
If no mark is detected within a mark window, bit 21 of the St
atus signal parameter will display
"Mark failed". 40x5040:110
Aer the maximum number of failed marks set in the Maximum number of failed marks
parameter, a corresponding error is displayed in the status of the technology applicaon.
40x5041:010
Parameter
Address Name / seng range / [default seng] Info
0x5041:010 Max. number of missed marks
0 ... [20] ... 4294967295
Conguring the "Sync and Correcon" TA
Mas
ter value correcon (register control)
Mark failure detecon
139