Lenze i950

7 Conguring the "Sync and Correcon" TA
The technology applicaon "Sync and Correcon" is used in the following applicaon areas:
•
Prinng elements
•
Perforang machines
•
Inse
t machines
•
Vibraon drives
•
Line drives
•
Labelling machines
The "Sync and Correcon" technology applicaon allows a precise angular synchronism to be
realised between the drives.
•
The c
onversion rao is freely adjustable.
•
V
arious interfaces can be used for master value selecon:
•
Virtual mas
ter
•
System bus
•
Encoder
The technology applicaon is set up using the following funcons:
4Virtual mas
ter ^ 104
4
Posion trimming and posion oset ^ 116
4Posion oset from master ^ 120
4Posion synchronism ^ 121
4Posion clutch ^ 123
4Mas
ter value correcon (register control) ^ 134
4T
ool correcon ^ 143
The technology applicaon can also be used for status display and error messages, or to reset
an error.
The technology applicaon "Sync and Correcon" only supports "modulo" axes. This means:
•
The mas
ter axis must be a "modulo" axis.
•
The slave axis must be a "modulo" axis.
Seng of the control mode
The control mode of the slave axis is congured by seng the parameter De
fault control
mode to "Posion control motor encoder [0]”; otherwise, the axis will dri at standsll.
40x500A:090
Conguring the "Sync and Correcon" TA
89