Chapter 5 LD Edit
5-53
3) Go To Rung Comment
[Steps]
1. Select [Find/Replace]-[Go To]-[Rung Comment].
[Dialog Box]
[Description of Dialog Box]
a. Program: used to display the list of the present PLC programs. If ‘All Programs’ is selected, the list of all
the rung comments will be displayed.
b. Rung comment list: used to display the list of the rung comments used in the selected program.
c. Go to: closes the Dialog Box to go to the selected rung comment.
d. Cancel: closes the Dialog Box.
2. Select the rung comment to go to on the Dialog Box.
Notes
- Go To Rung Comment is available only in the LD Program.
- The LD used for SFC Action/Transition is not available in Go To.
a
b
c
d
To Next Page
Loading...
