Chapter 2 Basic Application
2-7
6) Monitor
Instruction Description
Start/Stop Monitoring Starts or stops the monitor.
Pause Temporarily stops the monitor.
Resume Restarts the monitor temporarily stopped.
Pausing Conditions Specifies conditions for the monitor temporary stop.
Change Current Value Specifies the device value being monitored.
System Monitoring Executes the system monitor.
Device Monitoring Executes the device monitor.
Special Module Monitoring Executes the special module monitor.
Trend Monitoring Executes the trend monitor.
Custom Events Specifies the custom events.
Data Traces Specifies the device to monitor the change of the data.
7) Debug
Instruction Description
Start/Stop Debugging Converts to Debug mode to Start/Stop Debugging.
Go Runs to the break point.
Step Over Runs step by step.
Step Into Debugs the subroutine.
Step Out Escapes from the subroutine.
Go to Cursor Runs to the cursor position.
Set/Remove Breakpoints Sets or cancels the break point.
Breakpoints List Displays the list of the break points specified.
Breakpoint Conditions Specifies the break conditions
8) Tools
Instruction Description
Network Manager Shows the PLC network and specifies the parameter.
Start/End Simulator Starts or ends the simulator.
Customize User defines tools and instructions.
Shortcut Settings User specifies the Shortcut Keys.
Options Changeable applicably to XG5000 environment by user.
To Next Page
Loading...
