Chapter 16 XG-SIM
16-19
For instance, to simulate the PLC system with the following configuration, it is necessary to set I/O parameter as presented in the figure.
Base Slot Module Module type
Basic base 0 XGI-D21A DC 24V 8 point input module
Basic base 1 XGF-AV8A Voltage type A/D conversion module(8 ch)
Basic base 2 XGF-HO2A Open collector type high speed counter module(2 ch)
After XG-SIM is executed, system monitor shows the module set in I/O parameter as presented in the figure.
Notes
- For details of I/O parameter editing and the parameter setting by modules, refer to XG5000 Manual.
- To apply the details of I/O parameter set in XG5000, it is necessary to download I/O parameter to XG-SIM again. If the
type of a selected module is changed, XG-SIM should be executed again.
2) Digital I/O Module
Digital I/O module simulation may change the current value of contact or simulate whether the output used as the output in the program
is normally outputted. It may be different as follows, depending on the I/O module setting in I/O parameter.
Not setting I/O module Setting I/O module
Change Input
Use the monitor’s current value
change
Use the XG-SIM channel value
change
Change output Unable to change Unable to change
Forcible I/O input Not applicable Input forcibly set input
Forcible I/O
output
Not applicable Output forcibly set output
To Next Page
Loading...
