LSIS LSLV-S100 - Page 114

100
Learning Basic Features
Basic Tasks
Description
Ref.
without losing or altering saved parameter settings. It can
also be used to override remotes and use the keypad
immediately in emergencies.
Motor rotation control
Configures the inverter to limit a motor’s rotation direction.
p.122
Automatic start-up at
power-on
Configures the inverter to start operating at power-on. With
this configuration, the inverter begins to run and the motor
accelerates as soon as power is supplied to the inverter.
To use automatic start-up configuration, the operation
command terminals at the terminal block must be turned
on.
p.123
Automatic restart after
reset of a fault trip
condition
Configures the inverter to start operating when the inverter
is reset following a fault trip. In this configuration, the
inverter starts to run and the motor accelerates as soon as
the inverter is reset following a fault trip condition.
For automatic start-up configuration to work, the operation
command terminals at the terminal block must be turned
on.
p.123
Acc/Dec time configuration
based on the Max.
Frequency
Configures the acceleration and deceleration times for a
motor based on a defined maximum frequency.
p.125
Acc/Dec time configuration
based on the frequency
reference
Configures acceleration and deceleration times for a motor
based on a defined frequency reference.
p.126
Multi-stage Acc/Dec time
configuration using the
multi-function terminal
Configures multi-stage acceleration and deceleration times
for a motor based on defined parameters for the multi-
function terminals.
p.127
Acc/Dec time transition
speed (frequency)
configuration
Enables modification of acceleration and deceleration
gradients without configuring the multi-functional terminals.
p.129
Acc/Dec pattern
configuration
Enables modification of the acceleration and deceleration
gradient patterns. Basic patterns to choose from include
linear and S-curve patterns.
p.130
Acc/Dec stop command
Stops the current acceleration or deceleration and controls
motor operation at a constant speed. Multi-function
terminals must be configured for this command .
p.132
Linear V/F pattern
operation
Configures the inverter to run a motor at a constant torque.
To maintain the required torque, the operating frequency
may vary during operation.
p.132
Square reduction V/F
pattern operation
Configures the inverter to run the motor at a square
reduction V/F pattern. Fans and pumps are appropriate
loads for square reduction V/F operation.
p.133
User V/F pattern
configuration
Enables the user to configure a V/F pattern to match the
characteristics of a motor. This configuration is for special-
purpose motor applications to achieve optimal
performance.
p.134
Manual torque boost
Manual configuration of the inverter to produce a
p.135