LSIS LSLV-S100 - Page 261

Learning Advanced Features
247
Code
Description
3
Output
Voltage
Displays output voltage.
4
Output Power
Displays output power.
5
WHour
Counter
Displays inverter power consumption.
6
DCLink
Voltage
Displays DC link voltage within the inverter.
7
DI Status
Displays input terminal status of the
terminal block. Starting from the right,
displays P1–P8.
8
DO Status
Displays output terminal status of the
terminal block. Starting from the right,
Relay1, Relay2, and Q1.
9
V1 Monitor[V]
Displays the input voltage value at terminal
V1 (V).
10
V1 Monitor[%]
Displays input voltage terminal V1 value as
a percentage. If -10V, 0V, +10V is
measured,
-100%, 0%, 100% will be displayed.
13
V2 Monitor[V]
Displays input voltage terminal V2 value
(V).
14
V2 Monitor[%]
Displays input voltage terminal V2 value as
a percentage.
15
I2 Monitor[mA]
Displays input current terminal I2 value (A).
16
I2 Monitor[%]
Displays input current terminal I2 value as
a percentage.
17
PID Output
Displays output of PID controller.
18
PID Ref Value
Displays reference value of PID controller.
19
PID Fdb Value
Displays feedback volume of PID
controller.
20
Torque
If the torque reference command mode
(DRV-08) is set to a value other than
keypad (0 or 1), the torque reference value
is displayed.
21
Torque Limit
If torque limit setting (Cn.53) is set to a
value other than keypad (0 or 1), the torque
limit value is displayed.
23
Spd Limit
If the speed limit setting (Cn.62) on torque
control mode is set to a value other than
keypad (0 or 1), the speed limit setting is
displayed.
24
Load Speed
Displays the speed of a load in the
desired scale and unit. Displays the
speed of a load that ADV-61 (Load Spd
Gain) and ADV-62 (Load Spd Scale) are