Step 1 Front Cover, Control Terminal Cover and Cable Guide
The front cover, control terminal cover and cable guide must be removed to install cables.
Refer to the following procedures to remove the covers and cable guide. The steps to
remove these parts may vary depending on the inverter model.
0.8–1.5kW (single phase), 1.5–2.2kW (3-phase)
1 Loosen the bolt that secures the front cover (right side). Push and hold the latch on the
right side of the cover. Then remove the cover by lifting it from the bottom and moving it
away from the front of the inverter.
To Next Page
Loading...
