T–114
CRUISE CONTROL SYSTEM
ACTUATOR CABLE INSTALLATION
A6E812866311W02
1. Slide the lock lever in the direction shown by the
arrow to unlock the adjuster.
2. Turn the ratchet ring to release lock in the
direction shown by the arrow.
3. Install the actuator cable to the cruise actuator.
Caution
• Due to the possibility of actuator cable
damage, make sure there is no twisting in
the cable when installing.
4. Install the cruise actuator. (See T–110 CRUISE
ACTUATOR REMOVAL/INSTALLATION.)
5. Pass the actuator cable under the accelerator
cable.
6. Install the actuator cable to the bracket.
A6E8128W009
A6E8128W010
A6E8128W005
A6E8128W004
To Next Page
Loading...
