F–34
FUEL SYSTEM
PRESSURE REGULATOR INSPECTION
A6E391213280W01
Note
• Due to the adoption of the mechanical returnless fuel system, the pressure regulator cannot be inspected
separately.
1. Perform “FUEL LINE PRESSURE INSPECTION”. (See F–20 FUEL LINE PRESSURE INSPECTION.)
End Of Sie
PULSATION DAMPER REMOVAL/INSTALLATION
A6E391220180W01
1. Remove and install the pressure regulator.(See F–28 FUEL INJECTOR REMOVAL/INSTALLATION.)
End Of Sie
PULSATION DAMPER INSPECTION
A6E391220180W02
1. Complete the “BEFORE REPAIR PROCEDURE”. (See F–17 BEFORE REPAIR PROCEDURE.)
2. Remove the pulsation damper. (See F–34 PULSATION DAMPER REMOVAL/INSTALLATION.)
3. Visually inspect the pulsation damper for damage and cracks. Also verify that there is no extreme rust which
will cause fuel leakage.
• If either is observed, replace the pulsation damper.
4. Complete the “AFTER REPAIR PROCEDURE”. (See F–17 AFTER REPAIR PROCEDURE.)
End Of Sie
To Next Page
Loading...
