Mazda 2002 6 - Rear Wheel Alignment

R–6
WHEEL ALIGNMENT
REAR WHEEL ALIGNMENT
A6E741201016W01
Specification (Unloaded)*
1
Normal
Elevated
*3
*
1
: Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.
*
2
: Difference between left and right must not exceed 1°30'.
*3
: Distance between wheel center and fender brim is 392 mm {15.4 in} (reference value).
Note
• Adjust the toe-in after adjusting the camber.
Camber Adjustment
1. Loosen the cam nut on the lower arm.
2. Turn the adjusting cam bolt to provide the correct
camber angles as indicated.
3. Tighten the cam nut.
Tightening torque
86.2—116.6 N·m
{8.79—11.88 kgf·m, 63.58—85.99 ft·lbf}
Total Toe-in Adjustment
1. Loosen the locknut of the lateral link.
Item
Fuel gauge indication
Empty 1/4 1/2 3/4 Full
Total toe-in
(mm {in}) Tire: 2±4 {0.08±0.16}, Rim inner: 1±3 {0.04±0.12}
(degree) 0°11′±0°22′
Camber angle*
2
–1°05′±1° –1°07′±1° –1°09′±1° –1°11′±1° –1°13′±1°
Thrust angle (degree) 0°±0°48′
Item
Fuel gauge indication
Empty 1/4 1/2 3/4 Full
Total toe-in
(mm {in}) Tire: 2±4 {0.08±0.16}, Rim inner: 1±3 {0.04±0.12}
(degree) 0°11′±0°22′
Camber angle*
2
–0°56′±1° –0°58′±1° –1°00′±1° –1°02′±1° –1°05′±1°
Thrust angle (degree) 0°±0°48′
Left wheel Right wheel
Positive direction Clockwise
Counter-
clockwise
Negative direction
Counter-
clockwise
Clockwise
A6E7412W003
A6E7412W004