T–96
AUDIO AND NAVIGATION SYSTEM
CENTER PANEL MODULE REMOVAL/INSTALLATION
A6E812466900W02
1. Cancel the anti-theft operation. (with anti-theft system) (See T–93 ANTI-THEFT SYSTEM.)
2. Disconnect the negative battery cable.
3. Remove the glove compartment.
4. Remove the rear console.
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
Caution
• Make certain that the wiring harness and
antenna feeder are not caught between
the unit and dashboard. If the harness or
the antenna feeder is caught between the
unit and dashboard, it may cause trouble
or malfunctions.
7. Operate the anti-theft system by setting the code number. (with anti-theft system) (See T–93 ANTI-THEFT
SYSTEM.)
Center Panel Module Removal Note
1. Pull the center panel module toward you, then
disengage clip A from the dashboard, and remove
the center panel module.
End Of Sie
1 Dial (manual A/C only)
2 Screw (manual A/C only)
3Screw
4Bolt
5 Center panel module
(See T–96 Center Panel Module Removal Note)
6 Connector
7 Antenna feeder
A6E8124W020
A6E8124W029
To Next Page
Loading...
