M–16
DRIVE SHAFT
Dust Seal (Left) Assembly Note
1. Apply grease to the new dust seal lip.
2. Install the new left side dust seal using a steel
plate and the SSTs.
Joint Shaft Assembly Note
1. Assemble the joint shaft using a press and the
SST.
End Of Sie
DRIVE SHAFT PRE-INSPECTION
A6E631625500W01
1. Inspect the dust boot on the drive shaft for cracks,
damage, leaking grease, and looseness in the
boot band.
2. Inspect the drive shaft for bends, cracks, and
wear in the joint or splines.
• Repair or replace the drive shaft or boot/band
as necessary.
End Of Sie
A6E0313W030
A6E0313W029
A6E0313W033
To Next Page
Loading...
