FRONT SUSPENSION
R–21
R
2. Press the bushing in to the marking using the
SSTs.
3. Verify that clearance distance A—B is 23.75
mm—25.75 mm {0.936 in—1.013 in}.
Clip Installation Note
1. Wipe the grease off the ball stud.
2. Fill the inside of the new dust boot with grease.
3. Install the boot on the ball joint.
4. Install the new clip using the SST.
5. Verify that the clip is installed securely to the
groove.
6. Wipe away the excess grease.
Front Lower Arm (Rear) Installation Note
1. Install the lower arm (rear) so that identification mark (L or R) faces toward the front of the vehicle.
End Of Sie
FRONT LOWER ARM (REAR) INSPECTION
A6E741434300W04
1. Remove the lower arm (rear) from the vehicle.
2. Inspect for damage, cracks, and bending.
3. Inspect the ball joint rotation torque.
(1) Rotate the ball joint five times.
(2) Measure the rotation torque using a suitable
allen socket and a torque wrench.
• If not within the specification, replace the
lower arm component.
Rotation torque
1.00—2.22 N·m
{10.2—22.6 kgf·cm, 8.86—19.6 in·lbf}
End Of Sie
A6E7414W027
A6E7414W028
A6E7414W025
A6E7414W045
To Next Page
Loading...
