F–38
EMISSION SYSTEM
CHARCOAL CANISTER INSPECTION
A6E391613970W01
1. Remove the charcoal canister.
2. Plug the atmosphere side port and purge solenoid valve side port of the charcoal canister.
3. Blow air into the charcoal canister from the fuel tank side port and verify that there is no air leakage.
• If there is air leakage, replace the charcoal canister.
End Of Sie
EVAPORATIVE GAS CHECK VALVE (ONE-WAY) INSPECTION (L.H.D.)
A6E391613988W01
1. Remove the evaporative gas check valve (one-way).
2. Apply pressure to port A, and verify that there is no airflow.
• If there is airflow, replace the evaporative gas check valve (one-way).
3. Apply negative pressure to port A, and verify that there is air flow.
• If there is no airflow, replace the evaporative gas check valve (one-way).
End Of Sie
PURGE SOLENOID VALVE REMOVAL/INSTALLATION
A6E391618740W01
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Vacuum Hose Installation Note
1. Attach the vacuum hose onto the purge solenoid valve until it contacts the stopper.
Evaporative Hose Installation Note
1. Attach the evaporative hose onto the purge solenoid valve until it contacts the stopper.
End Of Sie
EMISSION SYSTEM
A6E3916W002
A6E3916W001
1 Evaporative hose (to charcoal canister)
(See F–38 Evaporative Hose Installation Note)
2 Vacuum hose (to intake manifold)
(See F–38 Vacuum Hose Installation Note)
3 Purge solenoid valve
A6E3916W024
To Next Page
Loading...
