S–36
POWER DOOR LOCK SYSTEM
End Of Sie
DOOR LOCK TIMER UNIT ID CODE CHANGE
A6E771801097W01
Note
• When programming the ID code into a door lock timer unit, verify that other transmitters are not being
operated in the vicinity.
End Of Sie
START
Remove key from steering lock.
Close all doors and liftgate (5HB)
or trunk lid (4SD).
Open driver-side door.
1. Insert key into steering lock.
2. Repeat the following three times.
Turn ignition switch to ON position, then
back to LOCK position.
Do not remove key from steering lock.
Push driver-side door switch three times.
Verify that door lock actuators lock, then unlock.
Push any button on any single transmitter twice.
Verify that door lock actuators lock, then unlock.
If you have only one transmitter, push any button
twice.
If you have two or three transmitters, push any
button on any of the other transmitter (s) twice.
Verify that door lock actuators lock, then unlock.
If you have one or two transmitters, push any
button on either transmitter twice.
If you have three transmitters, push any button
on the last transmitter twice.
Verify that door lock actuators lock, then unlock.
END
NO
NO
NO
NO
OK
OK
OK
OK
Verify that door
lock actuator
repeats locking
and unlocking
operation twice.
Push driver-side
door switch.
Perform these
procedures within
24 s.
Note
Wait for 40 s.
A6E914ZWB001
To Next Page
