Mazda 2002 6 - Dtc 05:Er07; Dtc 06:Er01

ON-BOARD DIAGNOSTIC [AUDIO]
T–173
T
Diagnostic procedure
End Of Sie
DTC 05:ER07
A6E817566900W19
Diagnostic procedure
End Of Sie
DTC 06:ER01
A6E817566900W20
Diagnostic procedure
STEP INSPECTION ACTION
1 VERIFY WHETHER MALFUNCTION IS IN CD
CHANGER OR OTHER PARTS
• Operate changer function.
• Is function okay?
Yes Go to Step 4.
No Not able to change particular
CD.
Go to next step.
Not able to change any CD. Go to Step 3.
2 INSPECT CD
• Inspect condition of CD where error has
occurred.
• Is CD okay?
Yes Go to next step.
No Repair (remove foreign material) or replace CD, then go to
next step.
3 INSPECT MAGAZINE
• Inspect magazine.
• Is magazine okay?
Yes Go to next step.
No Repair or replace magazine, then go to next step.
4 INSPECT CD CHANGER (EXTERNAL TYPE)
• Clear DTC.
• Operate changer.
• Start on-board diagnostic test mode.
• Is DTC 05:Er01 displayed?
Yes Replace CD changer (external type).
No Troubleshooting completed.
DTC 05:Er07 CD changer (external type)
DETECTION
CONDITION
Note
• When error occurs, error message “CHECK CD” is displayed in the LCD.
• Base unit detects CD reading error.
POSSIBLE
CAUSE
• Defective CD (scratches or dirt)
• CD changer (external type) malfunction
STEP INSPECTION ACTION
1 VERIFY WHETHER MALFUNCTION IS IN CD
CHANGER OR OTHER PARTS
• Play all CD in magazine.
• Is CD changer able to read them properly?
Yes Go to Step 3.
No Not able to change particular
CD.
Go to next step.
Not able to change any CD. Go to Step 3.
2 INSPECT CD
• Inspect condition of CD where error has
occurred.
• Is CD okay?
Yes Go to next step.
No Repair (remove foreign material) or replace CD, then go to
next step.
3 INSPECT CD CHANGER (EXTERNAL TYPE)
• Clear DTC.
• Insert and play CD with no defect.
• Start on-board diagnostic test mode.
• Is DTC 05:Er07 displayed?
Yes Replace CD changer (external type).
No Troubleshooting completed.
DTC 06:Er01 CD changer (upper module)
DETECTION
CONDITION
• CD changer (upper module) cannot implement insert, eject, and disc change commands.
POSSIBLE
CAUSE
• Defective CD (broken or foreign material stuck/attached)
• CD changer (upper module) malfunction
STEP INSPECTION ACTION
1 • Is CD able to be ejected? Yes Go to next step.
No Replace CD changer (upper module).
2 INSPECT CD
• Inspect condition of CD where error has
occurred.
• Is CD okay?
Yes Go to next step.
No Repair (remove foreign material) or replace CD, then go to
next step.