FRONT AXLE, REAR AXLE
M–9
M
Locknut Installation Note
1. Install a new locknut and stake it as shown.
End Of Sie
WHEEL HUB, HUB SPINDLE PRE-INSPECTION
A6E631405000W01
Wheel Bearing Play Inspection
1. Position a dial indicator against the wheel hub.
2. Push and pull the wheel hub by hand in the axial
direction and measure the wheel bearing play.
Maximum wheel bearing play
0.05 mm {0.002 in}
3. If the bearing play exceeds the specification,
replace and tighten the locknut to the specified
torque and retest.
• Replace the wheel hub component as
necessary.
End Of Sie
A6E0312W015
REAR AXLE
A6E0312W019
To Next Page
Loading...
