Mazda 2002 6 - Front;Rear Abs Wheel-Speed Sensor Inspection

ABS/TCS
P–33
P
End Of Sie
FRONT/REAR ABS WHEEL-SPEED SENSOR INSPECTION
A6E692143720W02
Visual Inspection
1. Remove the wheel and tire, and inspect the sensor for looseness and damage. Replace the sensor if
necessary.
Clearance Inspection
1. Inspect the clearance between the wheel-speed
sensor and the sensor rotor.
Clearance
0.3—1.1 mm {0.012—0.043 in}
Resistance Inspection
1. Disconnect the ABS wheel-speed sensor connector.
2. Inspect the resistance at the ABS wheel-speed sensor.
• If not as specified, replace the ABS wheel-speed sensor.
Resistance
1.3—1.7 kilohm
Voltage Inspection
1. On level ground, jack up the vehicle and support it evenly on safety stands.
2. Disconnect the ABS wheel-speed sensor connector.
3. Inspect each sensor by rotating each wheel one revolution per second.
• If not as specified, replace the ABS wheel-speed sensor.
Voltage
0.25—1.2 V (AC)
Voltage Pattern Inspection
1. On level ground, jack up the vehicle and support it evenly on safety stands.
2. Disconnect the ABS wheel-speed sensor connector.
3. Using an oscilloscope, inspect voltage pattern for
distortion and noise by rotating each wheel.
• If there is distortion or noise, inspect the ABS
sensor rotor.
End Of Sie
A6E6921W003
A6E6921W004