AIR BAG SYSTEM
T–134–1
T
T–134
BODY ELECTRICAL SYSTEM
11. Press the activation switch on the SST
(Deployment tool) connected with 49 L066 002 (a
yellow connector) of the SST (Adapter harness),
and after 3 s, press the activation switch on the
other SST (Deployment tool) to operate (deploy)
the air bag module (both inflators).
Warning
• Verify that air bag module operation
(explosive) sound occurs twice. If no
operation (explosive) sound was heard or
a single operation (explosive) sound was
heard, both inflators would not have
operated (deployed) properly. This may
cause serious injury because the air bag module may operate (deploy) accidentally. If the two
operation (explosive) sounds are not heard, perform Step 11 again. In case that the two operation
(explosive) sounds in total are not verified even though Step 11 is performed again, leave the air
bag module alone for 30 min or more before getting near it again.
• The air bag module is very hot immediately after it is operated (deployed). You can be burned. Do
not touch the air bag module for at least 15 min after deployment.
12. Disconnect the SST (Deployment tool) from the SST (Adapter harness).
End Of Sie
AIR BAG SYSTEM
49 H066 002
ACTIVATION
SWITCH
A6E8130W028
To Next Page
Loading...
