Mazda 2002 6 - Page 1190

CONTROL SYSTEM
U–39
U
SOLAR RADIATION SENSOR REMOVAL/INSTALLATION
A6E854061751W01
1. Disconnect the negative battery cable.
2. Remove the solar radiation sensor from the
dashboard using a tape-wrapped flathead
screwdriver.
3. Install in the reverse order of removal.
End Of Sie
SOLAR RADIATION SENSOR INSPECTION
A6E854061751W02
1. Shine an incandescent light (60 W) on the solar radiation sensor from a distance of approximately 100 mm
{3.94 in}.
2. Connect positive (+) lead to terminal A and
negative (−) lead to terminal B of the solar
radiation sensor.
• If the output voltage is not above 0.45 V,
replace the solar radiation sensor.
End Of Sie
AMBIENT TEMPERATURE SENSOR REMOVAL/INSTALLATION
A6E854061764W01
1. Disconnect the negative battery cable.
2. Remove the radiator grille. (See S–50 RADIATOR GRILLE REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
A6E8540W017
A6E8540W058
1 Ambient tenperature sensor connector
2 Ambient temperature sensor
A6E8540W018