FUEL SYSTEM
F–29
F
• The locking coupler has two internal locking
tabs which retain the fuel pipe. Be sure that
the tab on the locking coupler is rotated until
it stops to release two internal locking tabs.
2. Cover the disconnected quick release connector
and fuel pipe with vinyl sheets or the like to
prevent them from being scratched or
contaminated with foreign material.
Fuel Injector Removal Note
Caution
• Use of a deformed injector retaining clip will cause the injector to not engage correctly. Always
use a new clip when reattaching the injector, otherwise it may cause the injector to rotate.
1. Insert a screwdriver between the injector cup and
the clip fingers.
Note
• When rotating the screwdriver to spread the
clip fingers, deform them sufficiently to make
sure they release from the notched edge of
the injector cup.
2. Rotate the screwdriver to spread the clip fingers
and remove them from the injector cup.
3. Pull the injector and clip out of the rail.
4. Remove the clip from the injector according to the
following:
(1) Grasp the clip with a pair of pliers.
A6E3912W002
A6E3912W039
A6E3912W040
A6E3912W041
To Next Page
Loading...
