CONVENTIONAL BRAKE SYSTEM
P–9
P
3. Inspect for continuity between the brake switch connector terminals.
• If not as specified, replace the brake switch.
End Of Sie
BRAKE PEDAL REMOVAL/INSTALLATION
A6E691243300W02
Caution
• The clearance between the brake switch and the brake pedal is automatically adjusted to the
correct amount when the brake switch connector is connected after the brake switch has been
properly installed. If the brake switch is not properly installed or the connector is connected
before installation, the clearance may be incorrect, causing a brake light malfunction. Therefore,
always verify that the brake switch is properly installed before connecting the connector.
• Once the brake switch clearance has automatically been adjusted, it cannot be adjusted again.
Therefore, replace the switch with a new one when replacing the power brake unit or the pedal, or
performing any procedure that changes the pedal stroke.
1. For ATX model, remove the lock unit with brake switch (R.H.D. only).
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Brake switch Installation Note
1. Fix the brake switch on a bracket with pressing down at 50 N {5.1 kgf·m, 37 ft·lbf}.
2. Rotate the brake switch 45° counterclockwise.
3. Verify that the brake switch is locked securely.
Brake Switch Connector Installation Note
1. Inspect the brake pedal. (See P–7 BRAKE PEDAL INSPECTION.)
2. With the brake pedal in its original position, install the brake switch to the brake switch connector.
End Of Sie
A6E6912W033
A6E6912W034
1 Brake switch connector
(SeeP–9 Brake Switch Connector Installation Note )
2 Spring pin
3Clevis pin
4 Brake pedal
5 Brake switch
(See P–9 Brake switch Installation Note)
6 Pedal pad
A6E6912W020
A6E6912W051
To Next Page
Loading...
