DYNAMIC STABILITY CONTROL
P–39
P
Connector Removal Note
1. Rotate the lock lever 40° to the direction A, then
push the lock lever to the direction B.
Caution
• After rotated the lever 40° , do not push
the lock lever to the direction C. The lock
lever will be damaged.
2. Verify that the lock lever is completely returned.
3. Remove the harness side connector to the
direction D.
DSC HU/CM and Bracket Removal/Installation Note
1. When removing/installing the DSC HU/CM from/to the vehicle, attach a strip of tape on the DSC HU/CM
connector to prevent brake fluid from entering.
Connector Installation Note
1. Verify that the connection part and waterproof packing are free of foreign material, then connect the connector.
2. Verify that the lock lever is completely pushed in.
End Of Sie
A6E6920W011
A6E6916W005
To Next Page
Loading...
