P–82
ON-BOARD DIAGNOSTIC (DYNAMIC STABILITY CONTROL)
Diagnostic procedure
STEP INSPECTION ACTION
1 INSPECT WHEEL-SPEED SENSOR CIRCUIT
FOR OPEN CIRCUIT
• Turn ignition key to OFF.
• Disconnect DSC HU/CM connector.
• Measure resistance between suspected
sensor terminals of DSC HU/CM connector
(harness side).
— RF wheel-speed sensor: M—I
— LF wheel-speed sensor: F—J
— RR wheel-speed sensor: K—H
— LR wheel-speed sensor: Q—N
• Is resistance within 1.3—1.7 kilohm?
Yes Go to next step.
No Go to Step 3.
To Next Page
Loading...
