Mitsubishi Electric MELSEC iQ-R Series - Page 1026

1024
7 APPLICATION INSTRUCTIONS
7.25 Clock Instructions
Processing details
• These instructions compare the band between the time data of lower limit value (s1) and the time data of upper limit value
(s2) with the time data (s3) to be compared, and according to the comparison result (below, within zone, or above), (d),
(d)+1, or (d)+2 is turned on.
Precautions
• Set (s1) to a value less than (s2). If (s1) is set to a value greater than (s2), (s2) is treated as the same value as (s1).
Operation error
Device Clock data Data range
(s1), (s2), (s3) Hour 0 to 23
(s1)+1, (s2)+1, (s3)+1 Minute 0 to 59
(s1)+2, (s2)+2, (s3)+2 Second 0 to 59
Error code
(SD0)
Description
3405H The value specified by (s1), (s2), or (s3) is outside the following range.
0 to 23
The value specified by (s1)+1, (s2)+1, (s3)+1, (s1)+2, (s2)+2, or (s3)+2 is outside the following range.
0 to 59
TZCP (s1) (s2) (s3) (d)
(d)
X0
(d)+1
(d)+2
Turns on when
Turns on when
Turns on when
(s1)
(s1)+1
(s1)+2
(s1)
(s1)+1
(s1)+2
(s3)
(s3)+1
(s3)+2
(s3)
(s3)+1
(s3)+2
(s3)
(s3)+1
(s3)+2
(s2)
(s2)+1
(s2)+2
(s2)
(s2)+1
(s2)+2
>
≤
≤
>