Mitsubishi Electric MELSEC iQ-R Series - Disabling Interrupt Programs with Specified Priority or Lower

544
7 APPLICATION INSTRUCTIONS
7.3 Program Execution Control Instructions
Disabling interrupt programs with specified priority or lower
DI
This instruction disables execution of interrupt programs with the specified priority or lower.
■Execution condition
Setting data
■Description, range, data type
■Applicable devices
Ladder ST
ENO:=DI_1(EN,s);
FBD/LD
( is replaced by DI_1.)
Instruction Execution condition
DI Every scan
Operand Description Range Data type Data type (label)
(s) Interrupt disable priority 1 to 8 16-bit unsigned binary ANY16
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(s)         
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(s)
EN ENO
s