Mitsubishi Electric MELSEC iQ-R Series - Outputting a Comparison Result of Single-Precision Real Numbers

7 APPLICATION INSTRUCTIONS
7.9 Real Number Instructions
709
7
Outputting a comparison result of single-precision real numbers
ECMP(P)
These instructions compare the single-precision real number data specified by (s1) with the single-precision real number data
specified by (s2), and according to the result (small, equal, or large), (d), (d)+1, or (d)+2 is turned on.
■Execution condition
Setting data
■Description, range, data type
■Applicable devices
*1 T, ST, and C cannot be used.
• The RnCPU and RnENCPU with firmware version "17" or later support these instructions. (Use an engineering tool with version "1.020W" or later.)
Ladder ST
ENO:=ECMP(EN,s1,s2,d);
ENO:=ECMPP(EN,s1,s2,d);
FBD/LD
Instruction Execution condition
ECMP
ECMPP
Operand Description Range Data type Data type (label)
(s1) Comparison data or the start device for storing the
comparison data
0, 2
-126
|(s1)|<2
128
Single-precision real
number
ANYREAL_32
(s2) Comparison data or the start device for storing the
comparison data
0, 2
-126
|(s2)|<2
128
Single-precision real
number
ANYREAL_32
(d) The start device where the comparison result is stored  Bit ANYBIT_ARRAY
(Number of elements: 3)
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(s1)   
(s2)   
(d) 
*1
     
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(s1) (s2) (d)
EN ENO
ds1
s2