21 A/D CONVERSION INSTRUCTIONS
21.2 Reading the User Range Setting Values
1727
21
21.2 Reading the User Range Setting Values
G(P).OGLOAD
These instructions read the offset/gain setting values of the user range settings of an analog module into the CPU module.
■Execution condition
■Description, range, data type
*1 When specifying setting data by using a label, define an array to secure enough operation area and specify an element of the array
label.
*2 When specifying setting data by using a label, use an array with two or more elements.
■Applicable devices
*1 FD cannot be used.
*2 FX and FY cannot be used.
*3 T, ST, C, and FD cannot be used.
Ladder ST
ENO:=G_OGLOAD(EN,U,s,d);
ENO:=GP_OGLOAD(EN,U,s,d);
FBD/LD
Instruction Execution condition
G.OGLOAD
GP.OGLOAD
Operand Description Range Data type Data type (label)
(U) Start I/O number (first three digits in four-digit hexadecimal
representation) of a module
00H to FEH • 16-bit unsigned
binary
• 16-bit signed binary
ANY16
(s) Start device where the control data is stored Predefined devices Device name ANY16
*1
(d) Device to be turned on one scan when instruction
processing completes.
If the instruction is completed with an error, (d)+1 is also
turned on.
Predefined devices Bit ANYBIT_ARRAY
*2
(Number of elements: 2)
EN Execution condition Bit BOOL
ENO Execution result Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
(U)
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(U)
(s)
*1
(d)
*2
*3
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant)
(Process)
To Next Page
Loading...
