1726
21 A/D CONVERSION INSTRUCTIONS
21.1 Switching the Mode
• Program example
In the following cases, the G(P).OFFGAN instruction will be disabled.
• The module has been set as a target of synchronization.
• The simultaneous conversion mode has been selected on the high speed analog-digital converter module.
• The wave output mode has been selected on the D/A converter module.
• The high-speed output mode has been selected on the high speed digital-analog converter module.
There is no operation error.
(16) Shifts to offset/gain setting mode.
(77) Describes the offset/gain setting processing.
(111) Shifts to normal mode.
(172) Describes the normal mode processing.
To Next Page
Loading...
