Mitsubishi Electric MELSEC iQ-R Series - Pausing a Block

13 SFC PROGRAM INSTRUCTIONS
13.1 SFC Control Instructions
1429
13
Pausing a block
PAUSE [BL]
This instruction temporarily stops the step sequence in the specified block.
■Execution condition
Setting data
■Description, range, data type
■Applicable devices
*1 The BL can be index modified.
• The RnCPU and RnENCPU with firmware version "12" or later support this instruction. (Use an engineering tool with version "1.015R" or later.)
• The RnPCPU (process) with firmware version "03" or later supports these instructions. (Use an engineering tool with version "1.020W" or later.)
Ladder ST
ENO:=PAUSE(EN,d);
FBD/LD
Instruction Execution condition
PAUSE
Operand Description Range Data type Data type (label)
(d) Block No. where the sequence is temporarily stopped  Bit ANY_BOOL
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
(BL)
X, Y, M, L,
SM, F, B, S,
SB, FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(d)         
*1
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(d)
EN ENO
d