Mitsubishi Electric MELSEC iQ-R Series - Converting 32-Bit Signed Binary Data to 32-Bit Unsigned Binary Data

418
6 BASIC INSTRUCTIONS
6.6 Data Conversion Instructions
Converting 32-bit signed binary data to 32-bit unsigned binary
data
DINT2UDINT(P)
These instructions convert the specified 32-bit signed binary data to 32-bit unsigned binary data.
*1 The engineering tool with version "1.035M" or later supports the ST.
■Execution condition
Setting data
■Description, range, data type
■Applicable devices
The DINT2UDINT(P) instruction is used in programming using labels. The purpose of using this instruction is
to match the data type of the specified label with the data type that can be specified by the instruction
operand.
In programming using devices, use of the DINT2UDINT(P) instruction is not required.
Ladder ST
*1
ENO:=DINT2UDINT(EN,s,d);
ENO:=DINT2UDINTP(EN,s,d);
FBD/LD
Instruction Execution condition
DINT2UDINT
DINT2UDINTP
Operand Description Range Data type Data type (label)
(s) Binary data or the label where the binary data is stored -2147483648 to 2147483647 32-bit signed binary ANY32_S
(d) Label for storing the converted binary data  32-bit unsigned binary ANY32_U
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(s)         
(d)         
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(s) (d)
EN ENO
ds