Mitsubishi Electric MELSEC iQ-R Series - Deleting Data from Data Table

7 APPLICATION INSTRUCTIONS
7.5 Data Table Operation Instructions
591
7
Deleting data from data table
FDEL(P)
These instructions delete the data at the (n)th position in the data table.
■Execution condition
Setting data
■Descriptions, ranges, and data types
*1 When specifying setting data by using a label, define an array to secure enough operation area and specify an element of the array
label.
■Applicable devices
Ladder ST
ENO:=FDEL(EN,s,n,d);
ENO:=FDELP(EN,s,n,d);
FBD/LD
Instruction Execution condition
FDEL
FDELP
Operand Description Range Data type Data type (label)
(s) Device where the data to be deleted is stored  16-bit signed binary ANY16
(d) Start device of table  Word ANY16
*1
(n) Deletion position in the table 0 to 65535 16-bit unsigned binary ANY16
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(s)         
(d)         
(n)         
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(s) (d) (n)
EN ENO
sd
n