Mitsubishi Electric MELSEC iQ-R Series - Adding Expansion Clock Data

7 APPLICATION INSTRUCTIONS
7.25 Clock Instructions
1027
7
Adding expansion clock data
S(P).DATE+
These instructions add time data.
*1 The engineering tool with version "1.035M" or later supports the ST.
■Execution condition
Setting data
■Descriptions, ranges, and data types
■Applicable devices
Ladder ST
*1
ENO:=S_DATEPLUS(EN,s1,s2,d);
ENO:=SP_DATEPLUS(EN,s1,s2,d);
FBD/LD
( is replaced by either of the following: S_DATEPLUS, SP_DATEPLUS.)
Instruction Execution condition
S.DATE+
SP.DATE+
Operand Description Range Data type Data type (label)
(s1) Start device where the augend clock data is stored Refer to "Processing
details".
16-bit signed binary ANY16_ARRAY
(Number of elements: 5)
(s2) Start device where the addend time (clock) data is stored Refer to "Processing
details".
16-bit signed binary ANY16_ARRAY
(Number of elements: 5)
(d) Start device for storing the addition result time (clock) data  16-bit signed binary ANY16_ARRAY
(Number of elements: 5)
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(s1)         
(s2)         
(d)         
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(s1) (s2) (d)
EN ENO
ds1
s2