Mitsubishi Electric MELSEC iQ-R Series - Changing the Program Execution Type to Standby Type; Program Control Instructions

7 APPLICATION INSTRUCTIONS
7.30 Program Control Instructions
1079
7
7.30 Program Control Instructions
Changing the program execution type to standby type
PSTOP(P)
These instructions change the execution type of the program with the file name stored in the specified device to a standby
type.
■Execution condition
Setting data
■Description, range, data type
■Applicable devices
• [RnPCPU (redundant)] If these instructions are used in a program executed in both systems, the execution type is not taken over when the systems are
switched. ( MELSEC iQ-R CPU Module User's Manual (Application))
Ladder ST
FILE: File name
ENO:=PSTOP(EN,filename);
ENO:=PSTOPP(EN,filename);
FBD/LD
FILE: File name
Instruction Execution condition
PSTOP
PSTOPP
Operand Description Range Data type Data type (label)
(file name) Character string data of the file name of the program to be
changed to a standby type, or the start device where the
character string data is stored
 Unicode string ANYSTRING_DOUBLE
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(file name)   
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(FILE)
EN ENO
FILE