Mitsubishi Electric MELSEC iQ-R Series - Jumping to END

540
7 APPLICATION INSTRUCTIONS
7.2 Program Branch Instructions
Jumping to END
GOEND
This instruction jumps the program to the FEND or END instruction within the same program file.
■Execution condition
Processing details
• This instruction jumps the program to the FEND or END instruction within the same program file.
Operation error
Ladder ST
Not supported
FBD/LD
Not supported
Instruction Execution condition
GOEND
Error code
(SD0)
Description
3340H After execution of the FOR instruction, the GOEND instruction is executed before the NEXT instruction.
3381H After execution of the CALL(P) or ECALL(P) instruction, the GOEND instruction is executed before the RET instruction.
33A1H The GOEND instruction is executed before the IRET instruction in the interrupt program specified by the interrupt pointer (I).
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)