Mitsubishi Electric MELSEC iQ-R Series - Stop Instruction; Stopping the Sequence Program

5 SEQUENCE INSTRUCTIONS
5.7 Stop Instruction
215
5
5.7 Stop Instruction
Stopping the sequence program
STOP
This instruction stops the operation of the CPU module. (The operation of this instruction is the same as setting the switch of
the CPU module to the STOP position.)
■Execution condition
Processing details
• This instruction resets the output (Y) and stops the operation of the CPU module when the execution command turns on.
(The operation of this instruction is the same as setting the switch of the CPU module to the STOP position.)
• To restart the operation of the CPU module after execution of the STOP instruction, set the switch back to STOP, and then
set it to RUN again.
Operation error
Ladder ST
ENO:=STOP(EN);
FBD/LD
Instruction Execution condition
STOP
Error code
(SD0)
Description
3340H After execution of the FOR instruction, the STOP instruction is executed before the NEXT instruction.
3381H After execution of the CALL(P), FCALL(P), ECALL(P), EFCALL(P), or XCALL instruction, the STOP instruction is executed before the
RET instruction.
33A1H Within the interrupt program specified by the interrupt pointer (I), the STOP instruction is executed before the IRET instruction.
33A3H The STOP instruction is executed within a fixed scan execution type program.
33A4H The STOP instruction is executed within an event execution type program.
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
EN ENO