Mitsubishi Electric MELSEC iQ-R Series - Reinitializing the Module

1562
16 ETHERNET INSTRUCTIONS
16.4 Reinitializing the Module
16.4 Reinitializing the Module
G(P).UINI, Z(P).UINI
These instructions reinitialize the module. The UINI instruction can be used only when the network type is "Q-compatible
Ethernet".
■Execution condition
Setting data
■Description, range, data type
*1 When specifying setting data by using a label, define an array to secure enough operation area and specify an element of the array
label.
Ladder ST
ENO:=G_UINI(EN,U,s,d);
ENO:=GP_UINI(EN,U,s,d);
ENO:=Z_UINI(EN,U,s,d);
ENO:=ZP_UINI(EN,U,s,d);
FBD/LD
Instruction Execution condition
G.UINI
Z.UINI
GP.UINI
ZP.UINI
Operand Description Range Data type Data type (label)
(U) G(P).UINI Start I/O number (first three digits in four-digit
hexadecimal representation) of own station or own
node
00H to FEH 16-bit unsigned binary ANY16
Z(P).UINI Start I/O number (first three digits in four-digit
hexadecimal representation) of own station or own
node
00H to FEH String ANY16_OR_STRING_
SINGLE
(s) Start device of the own station where control data is
stored
Refer to the control data. Device name ANY16
*1
(d) Device of the own station, which turns on for one
scan upon completion of the instruction.
When the instruction completes with an error, (d)+1
also turns on.
 Bit ANYBIT_ARRAY
(Number of elements: 2)
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(U) (s) (d)
EN ENO
dU
s