186
5 SEQUENCE INSTRUCTIONS
5.3 Output Instructions
Long counter
OUT LC
This instruction increments the current long counter value (count value) by one on the rising edge (off to on) of the operation
result up to the OUT instruction. When the count value reaches the set value, the normally open contact of the long counter
turns on (continuity state) and the normally closed contact turns off (non-continuity state).
■Execution condition
■Description, range, data type
*1 Only long counter type labels can be used.
*2 If the program is written in ST language or FBD/LD, the data type will be ANY_INT.
■Applicable devices
*1 Only LC can be used.
*2 T, ST, and C cannot be used.
*3 Only K (decimal constant) can be used.
Ladder ST
Value: Set value
ENO:=OUT_C(EN,Coil,Value);
FBD/LD
Value: Set value
( is to be replaced by OUT_C.)
Instruction Execution condition
OUT LC Every scan
Operand Description Range Data type Data type (label)
(d) Long counter number Bit ANY_BOOL
*1
Coil
Value Set value for the long counter 0 to 4294967295 32-bit unsigned
binary
*2
ANY32
*2
EN Execution condition Bit BOOL
ENO Execution result Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LS T,
LC
LZ K, H E $
(d)
*1
Coil
Value
*2
*3
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant)
(Process)
To Next Page
Loading...
