13 SFC PROGRAM INSTRUCTIONS
13.1 SFC Control Instructions
1437
13
Switching a target block
BRSET
This instruction specifies an SFC control instruction target block No.
■Execution condition
■Description, range, data type
■Applicable devices
• The RnCPU and RnENCPU with firmware version "12" or later support this instruction. (Use an engineering tool with version "1.015R" or later.)
• The RnPCPU (process) with firmware version "03" or later supports these instructions. (Use an engineering tool with version "1.020W" or later.)
Ladder ST
ENO:=BRSET(EN,s);
FBD/LD
Instruction Execution condition
BRSET
Operand Description Range Data type Data type (label)
(s) Target block No. 16-bit signed binary ANY16
EN Execution condition Bit BOOL
ENO Execution result Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, S,
SB, FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(s)
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant)
(Process)
To Next Page
Loading...
