Mitsubishi Electric MELSEC iQ-R Series - Reading the Module Model Name

7 APPLICATION INSTRUCTIONS
7.27 Module Access Instructions
1063
7
Reading the module model name
TYPERD(P)
These instructions read the module name of the specified slot.
■Execution condition
Setting data
■Description, range, data type
■Applicable devices
Ladder ST
ENO:=TYPERD(EN,H,d);
ENO:=TYPERDP(EN,H,d);
FBD/LD
Instruction Execution condition
TYPERD
TYPERDP
Operand Description Range Data type Data type (label)
(H) Start I/O number (first three digits in four-digit hexadecimal
representation) of a model read target module
0H to FFH, 3E0H to
3E3H
16-bit unsigned binary ANY16
(d) (d)+0: Instruction execution result
(d)+1 to (d)+9: Module name
 Word ANY16_ARRAY
(Number of elements:
10)
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(H)         
(d)         
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(H) (d)
EN ENO
dH