Mitsubishi Electric MELSEC iQ-R Series - Disabling;Enabling the Specified Interrupt Pointer

7 APPLICATION INSTRUCTIONS
7.3 Program Execution Control Instructions
551
7
Disabling/enabling the specified interrupt pointer
SIMASK
This instruction enables or disables the execution of the interrupt program with the specified interrupt pointer number.
■Execution condition
Setting data
■Description, range, data type
*1 Only labels assigned to the device (I) can be used.
■Applicable devices
Ladder ST
ENO:=SIMASK(EN,I,s);
FBD/LD
Instruction Execution condition
SIMASK Every scan
Operand Description Range Data type Data type (label)
(I) Interrupt pointer number to be interrupt-enabled or -
disabled
I0 to I1023 Device name POINTER
*1
(s) Execution status of the specified interrupt pointer 0: Disabled
1: Enabled
16-bit unsigned binary ANY16
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
(I)
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(I)   
(s)   
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(I) (s)
EN ENO
I
s