Mitsubishi Electric MELSEC iQ-R Series - Batch-Reading the Status of Steps

1416
13 SFC PROGRAM INSTRUCTIONS
13.1 SFC Control Instructions
Batch-reading the status of steps
MOV(P) [K4S/BL\K4S]
These instructions batch-read (in units of 16-bit binary data) the status (active or inactive) of steps in the specified block, and
store the read data in the specified device.
■Execution condition
Setting data
■Description, range, data type
■Applicable devices
*1 Only S can be used.
• The RnCPU and RnENCPU with firmware version "12" or later support this instruction. (Use an engineering tool with version "1.015R" or later.)
• The RnPCPU (process) with firmware version "03" or later supports these instructions. (Use an engineering tool with version "1.020W" or later.)
Ladder ST
ENO:=MOV(EN,s,d);
ENO:=MOVP(EN,s,d);
FBD/LD
Instruction Execution condition
MOV
MOVP
Operand Description Range Data type Data type (label)
(s) Device number where the transfer source data is stored  16-bit signed binary ANY16
(d) Transfer destination device number  16-bit signed binary ANY16
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
(BL\
S)
X, Y, M, L,
SM, F, B, S,
SB, FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(s) 
*1
       
(d)         
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(s) (d)
EN ENO
ds