Mitsubishi Electric MELSEC iQ-R Series - Chapter 18 CC-Link Ie Field Network Instructions; Reading Data from the Intelligent Device Station;Remote Device Station (16-Bit Address Specified)

1600
18 CC-LINK IE FIELD NETWORK INSTRUCTIONS
18.1 Reading Data from the Intelligent Device Station/Remote Device Station (16-bit Address Specified)
18 CC-LINK IE FIELD NETWORK INSTRUCTIONS
This chapter describes the instructions used commonly by MELSEC iQ-R series modules. For the instructions
when MELSEC-Q series modules are used, refer to the manuals for each module used and create programs.
For precautions when using modules, refer to the following.
 MELSEC iQ-R Module Configuration Manual
18.1 Reading Data from the Intelligent Device Station/
Remote Device Station (16-bit Address Specified)
JP.REMFR, ZP.REMFR
These instructions read data from the buffer memory area of the intelligent device station or the remote device station (in units
of words, 16-bit address specified).
■Execution condition
Ladder ST
ENO:=JP_REMFR(EN,J,s1,s2,s3,s4,n,d1,d2);
ENO:=ZP_REMFR(EN,J,s1,s2,s3,s4,n,d1,d2);
FBD/LD
Instruction Execution condition
JP.REMFR
ZP.REMFR
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(J) (s1) (s2) (s3) (s4) (d1) (n) (d2)
EN
J
ENO
s1
s2
d1
d2
s3
s4
n