Mitsubishi Electric MELSEC iQ-R Series - Executing the Registered Protocols; Predefined Protocol Support Function Instruction

8 BUILT-IN ETHERNET FUNCTION INSTRUCTIONS
8.3 Predefined Protocol Support Function Instruction
1109
8
8.3 Predefined Protocol Support Function Instruction
Executing the registered protocols
SP.ECPRTCL
This instruction executes the protocol that has been set by the predefined protocol support function.
■Execution condition
Setting data
■Description, range, data type
Ladder ST
ENO:=SP_ECPRTCL(EN,U,s1,s2,s3,d);
FBD/LD
Instruction Execution condition
SP.ECPRTCL
Operand Description Range Data type Data type (label)
(U) Dummy  String ANYSTRING_SINGLE
(s1) Connection number 1 to 16 16-bit unsigned binary ANY16
(s2) Number of protocols to be executed continuously 1 to 8 16-bit unsigned binary ANY16
(s3) Start device where control data is stored Refer to the control data. Word ANY16_ARRAY
(Number of elements: 2)
(d) Device that turns on for one scan upon completion of the
instruction
When the instruction completes with an error, (d)+1 also
turns on.
 Bit ANYBIT_ARRAY
(Number of elements: 2)
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(U) (s1) (s2) (s3) (d)
EN ENO
U
s1
d
s2
s3