Mitsubishi Electric MELSEC iQ-R Series - Inverting the Bit Device Output

5 SEQUENCE INSTRUCTIONS
5.3 Output Instructions
201
5
Inverting the bit device output
FF
This instruction inverts the status of the specified device.
■Execution condition
Setting data
■Description, range, data type
• In safety programs executed by the Safety CPU, only safety devices and safety labels of data types described in the table
can be used.
■Applicable devices
• In safety programs executed by the Safety CPU, only the following safety devices and constants can be used.
Processing details
• This instruction inverts the status of the device specified by (d) on the rising edge of the execution command.
Ladder ST
ENO:=FF(EN,d);
FBD/LD
Instruction Execution condition
FF
Operand Description Range Data type Data type (label)
(d) Inversion target device number  Bit ANY_BOOL
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
(DY)
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LS T,
LC
LZ K, H E $
(d) 
Operand Bit Word Constant
SA\X, SA\Y, SA\M, SA\SM, SA\B SA\T, SA\ST, SA\C, SA\D, SA\W, SA\SD K, H
(d)  
Device Device status
Before execution of the FF instruction After execution of the FF instruction
Bit device Off On
On Off
Bit-specified word device 0 1
10
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(d)
EN ENO
d