Mitsubishi Electric MELSEC iQ-R Series - CHAPTER 23 High Speed Data Logger Module Instructions; File Access Instructions; Recipe Write

23 High Speed Data Logger Module Instructions
23.1 File Access Instructions
1781
23
23 High Speed Data Logger Module Instructions
This chapter describes the instructions used commonly by MELSEC iQ-R series modules. When using
MELSEC-Q series modules, refer to the manual for each module used and create programs.
For precautions when using modules, refer to the following.
 MELSEC iQ-R Module Configuration Manual
23.1 File Access Instructions
Recipe write
Z(P).RCPWRITE
These instructions write the data in the CPU module to the specified recipe file in the SD memory card.
■Execution condition
Setting data
■Description, range, data type
*1 When specifying setting data by using a label, define an array to secure enough operation area and specify an element of the array
label.
The local device and the file register for each program are not available for setting data.
Ladder ST
ENO:=Z_RCPWRITE(EN,U,s,d);
ENO:=ZP_RCPWRITE(EN,U,s,d);
FBD/LD
Instruction Execution condition
Z.RCPWRITE
ZP.RCPWRITE
Operand Description Range Data type Data type (label)
(U) Start I/O number (first three digits in four-digit hexadecimal
representation) of a module
00H to FEH String ANY16_OR_STRING_
SINGLE
(s) Start device where control data is stored Page 1782 Control data Device name ANY16
*1
(d) Device that turns on for one scan upon completion of the
instruction
When the instruction completes with an error, (d)+1 also
turns on.
 Bit ANYBIT_ARRAY
(Number of elements: 2)
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(U) (s) (d)
EN ENO
dU
s