Mitsubishi Electric MELSEC iQ-R Series - CC-Link IE Field Network Instructions

3 MODULE DEDICATED INSTRUCTIONS
3.4 CC-Link IE Field Network Instructions
137
3
3.4 CC-Link IE Field Network Instructions
Reading data from the intelligent device station/remote device station
Writing data to the intelligent device station/remote device station
Reading the module model information of an intelligent device station
Reading the module status information of an intelligent device station
Setting parameters
Setting the station number to own station
Instruction symbol Processing details Reference
JP.REMFR Reads data from the buffer memory area of the intelligent device station or the remote device
station in units of words (16-bit address specified).
Page 1600 JP.REMFR,
ZP.REMFR
ZP.REMFR
JP.REMFRD Reads data from the buffer memory area of the intelligent device station or the remote device
station in units of words (32-bit address specified).
Page 1610
JP.REMFRD
Instruction symbol Processing details Reference
JP.REMTO Writes data to the buffer memory area of the intelligent device station or the remote device station
in units of words (16-bit address specified).
Page 1605 JP.REMTO,
ZP.REMTO
ZP.REMTO
JP.REMTOD Writes data to the buffer memory area of the intelligent device station or the remote device station
in units of words (32-bit address specified).
Page 1615
JP.REMTOD
Instruction symbol Processing details Reference
J.SINFTYRD Reads the model names of modules and units used in an intelligent device station. Page 1620
J(P).SINFTYRD,
G(P)SINFTYRD
JP.SINFTYRD
G.SINFTYRD
GP.SINFTYRD
Instruction symbol Processing details Reference
J.SINFSTRD Reads the status information of modules and units used in an intelligent device station. Page 1624
J(P).SINFSTRD,
G(P)SINFSTRD
JP.SINFSTRD
G.SINFSTRD
GP.SINFSTRD
Instruction symbol Processing details Reference
G.CCPASET Sets parameters to the master, submaster, and local stations.
Use the G(P).CCPASET instruction to set parameters in the following cases.
• To change parameters without resetting the CPU module
• To install more modules than can be set by the engineering tool
Page 1629
G(P).CCPASET
GP.CCPASET
Instruction symbol Processing details Reference
G.UINI Sets the station number to the local station (own station).
Use the engineering tool or UINI instruction to set network parameters excluding the station
number.
Page 1635 G(P).UINI,
Z(P).UINI
GP.UINI
Z.UINI
ZP.UINI